MacDon CA25 OM - Manual (Page 131)

SECTION 8. MAINTENANCE AND SERVICING
169593
129
Revision B
8.8.4.2 Tine Installation
If replacing tine, proceed to step d. Otherwise,
proceed to step a.
a. Remove access cover (if applicable).
b. Remove cover at tine location (if applicable).
c. Install plastic guide.
d. Insert tine (D) through plastic guide (F) from
inside the auger.
e. Insert tine into bushing (E).
NOTE
The #6 tine (D) must also be inserted
through the square tube (G).
f. Secure tine in bushing with hairpin (C). Install
hairpin with closed end leading with respect to
auger forward rotation.
g. Replace access cover (B), and secure with
screws (A). Coat screws with Loctite
®
#243 (or
equivalent), and torque to 75 in·lbf (8.5 N·m).
B
A
G
D
F
E
D
C