MacDon CA25 OM - Manual (Page 77)

SECTION 7. OPERATION
169593
75
Revision B
7.9.9.2 Fore-Aft Cylinder Position: Double
Reel
The reel can be moved approximately nine
inches further aft by re-positioning the cylinders
on the reel arms. This may be desirable when
straight-combining canola.
a. Position reel fully aft with support arms
horizontal. Stop engine, and remove key.
WARNING
Stop combine engine, and remove key
before making adjustments to machine. A
child or even a pet could engage the drive.
b. Re-position center arm cylinder as follows:
NOTE
Reel components are not shown for
clarity.
1. Remove four bolts (A) securing cylinder
bracket (B) to reel arm.
2. Push reel back until bracket (B) lines up
with the aft set of holes (C).
3. Re-install the four bolts (A) to secure
bracket to reel arm at new position.
c. Re-position right arm cylinder as follows:
NOTE
Reel components are not shown for
clarity.
1. Remove four bolts (D) securing cylinder
bracket (E) to reel arm.
2. Push reel back until bracket (E) lines up
with the aft set of holes (F).
3. Re-install the four bolts (D) to secure
bracket to reel arm at new position.
(continued next page)
B
A
C
FORWARD POSITION
A
REARWARD POSITION
E
D
F
FORWARD POSITION
REARWARD POSITION
D