MacDon CA25 OM - Manual (Page 181)

SECTION 8. MAINTENANCE AND SERVICING
169593
179
Revision B
8.12.10 Tine Tube Bushings
CAUTION
To avoid bodily injury from fall of raised
reel, always engage reel props before
going under raised reel for any reason.
Lower header, raise reel fully and engage reel
stops.
8.12.10.1 Bushing Removal: 6 and 9-Bat
Pick-Up Reels
a. Remove bushings at center disc and left end
disc as follows:
1. Remove bolts (A) securing arm (B) to disc
at both locations.
IMPORTANT
Ensure tine tube is supported at all
times to prevent damage to the tube
or other components.
IMPORTANT
Note the hole locations in arm and
disc, and ensure bolts are
re-installed at original locations.
2. Release bushing clamps (C) using a small
screwdriver to separate the serrations. Pull
clamp off tine tube.
3. Rotate arm (B) clear of disc, and slide arm
inboard off bushing, and remove bushing
halves (D). Remove bolt from tine next to
arm (or remove plastic finger) if required so
that arm can slide off bushing.
b. Remove cam end bushings as follows:
1. Remove bolt (E) at on cam linkage so that
tine tube (F) is free to rotate.
2. If required, remove bolt (G) securing the
first tine to the left of the support so that
tine is free to move inboard (to the right). If
plastic finger is installed, refer to previous
section for removal procedure.
(continued next page)
B
A
F
E
G
B
D
C