MacDon CA25 OM - Manual (Page 92)

SECTION 7. OPERATION
169593
90
Revision B
7.15.3.1 Front Wheels To Field Position
DANGER
To avoid bodily injury or death from
unexpected start-up or fall of raised
header, stop engine, remove key, and
engage header lift cylinder stops before
going under header for any reason.
a. Raise header fully.
b. Swivel wheel assembly so that wheels are
aligned with lower frame.
c. Remove pin (A), and pull wheel assembly
towards rear of header. Store pin (A) in hole at
top of leg.
d. Pull handle (C) to release and lower the
linkage.
e. Align lift hook (D) with lug (E), and lift wheel
assembly to engage pin in hook. Ensure latch
(F) is engaged.
f. Install clevis pin (B), and secure with hairpin.
g. Lift wheel assembly to desired height, and slide
linkage (F) into appropriate slot in vertical
support.
h. Push down on handle (C) to lock.
TRANSPORT TO FIELD - FRONT WHEELS
E
D
B
F
TRANSPORT TO FIELD - FRONT WHEELS
RELEASE
LOCK
C
TRANSPORT TO FIELD - FRONT WHEELS
A
A
TRANSPORT TO FIELD - FRONT WHEELS
Release
Lock
F
C