MacDon CA25 OM - Manual (Page 106)

SECTION 8. MAINTENANCE AND SERVICING
169593
104
Revision B
8.4.1 Maintenance Schedule/Record
ACTION:  - Check  - Lubricate  - Change
MAINTENANC
E
RECORD
Hour Meter Reading
Date
Serviced By
FIRST USE Refer To Section 8.4.2 Break-In Inspections.
100 HOURS OR ANNUALLY
 Auger to Pan and Feed Draper Clearance
- Section 8.8.1

Draper Seal - Section 8.11.5

Gearbox Lubricant Level - Section 8.4.5.4

Reel Drive Chain Tension - Section 8.12.4
 Reel Tine / Cutterbar Clearance
- Section 8.12.1

Sickle Drive Belt Tension - Section 8.9.8

Wheel Bolt Torque - Section 8.13.1
 Sickle Drive Box Lubricant Level
- Section 8.4.5
 Sickle Drive Box Mounting Bolts
- Section 8.9.10.1

Auger Drive Chain - Section 8.8.2

Float Pivots - Section 8.4.5

Float Spring Tensioners - Section 8.4.5

Reel Drive Chain - Section 8.4.5
 Upper Cross Auger RH Bearing
- Section 8.4.5
END OF SEASON Refer To Section 8.4.4 End of Season.
10 HOURS OR DAILY
NOTE: A RECORD OF DAILY MAINTENANCE IS NOT
NORMALLY REQUIRED, BUT IS AT THE
OWNER/OPERATOR’S DISCRETION.

Hydraulic Hoses and Lines - Section 8.5.3
 Sections, Guards, Hold-downs
- Sections 8.9.1, 8.9.6, 8.9.7

Tire Pressure - Section 8.13.3
 Sickle (except in sandy conditions)
- Section 8.4.5
25 HOURS
 Hydraulic Oil Level at Reservoir
- Section 8.5.1.1

Sickle Head(s) - Section 8.4.5
(continued next page)