MacDon CA25 OM User Manual
Page 31
SECTION 7. OPERATION
169593
29
Revision B
7.3.1.2 Stripper
Bars
Stripper bar kits may have been supplied with
your header to improve feeding in certain crops
such as rice. Installation instructions are
included with the kits.
They are not recommended in cereal crops.
APPLICABLE COMBINES: All except New
Holland CR960, 9060, 970, 9070, and 9080.
If necessary, remove auger stripper bars as
follows:
a. Remove four bolts (A) and nuts securing bars
(B) to adapter frame and remove bars.
b. Repeat for opposite set of stripper bars.
7.3.1.3 Auger
Drive
The adapter auger is chain driven from a
sprocket that is mounted on the input shaft from
the combine, and which is enclosed in the drive
gearbox.
The speed is determined by the combine input
shaft, and is matched to each particular
combine, so no adjustment is necessary.
However, optional drive sprockets are available
to change the auger speed to optimize auger
performance. See your MacDon Dealer.
NOTE
For special conditions, 20T, 22T, and
26T sprockets are available to change
adapter feed auger speed. Consult
with your MacDon Dealer.
A
B