MacDon CA25 OM - Manual (Page 50)

SECTION 7. OPERATION - AGCO
169593
48
Revision B
c. Raise feeder house to lift adapter, ensuring
feeder house saddle (F) and alignment pins are
properly engaged in adapter frame.
d. Raise header slightly off the ground.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
e. Engage lugs (A) with adapter using lock handle
(B).
f. Connect adapter hydraulic quick coupler to
combine receptacle as follows:
1. Raise handle (G) to release coupler (H)
from adapter.
2. Push handle (J) on combine to full open
position.
3. Clean mating surfaces of coupler and
receptacle if necessary.
4. Position coupler (H) onto combine
receptacle (K), and pull handle (J) to fully
engage coupler into receptacle.
5. Connect reel fore-aft/header tilt selector
harness (L) to combine harness (M).
(continued next page)
K J
H
G
L
M
J
H
A
B
GLEANER ‘R’ & ‘S’ SERIES
B
ALL EXCEPT GLEANER ‘R’ & ‘S’ SERIES
A
F