MacDon CA25 OM - Manual (Page 56)

SECTION 7. OPERATION - ADAPTER
169593
54
Revision B
j. Disconnect knife and draper drive hydraulic
hoses at bracket. Cap off ends immediately to
avoid loss of oil.
k. Store and secure hoses on adapter frame.
l. If quick disconnects are installed, disconnect as
follows:
1. Line up slot (N) in collar with pin (O) on
connector.
2. Push collar toward pin, and pull connector
to disengage.
3. Install plugs or caps on hose ends
(if equipped).
m. Disconnect electrical connector (P) by turning
collar counterclockwise, and pulling connector
to disengage.
n. Store and secure hoses and electrical
connector on adapter.
o. Disconnect reel hydraulics. Cap off end
immediately to avoid loss of oil.
p. Store and secure hoses to adapter frame.
q. Ensure header is on ground, or is supported by
wheels in Transport mode.
r. Start engine, and slowly back combine away
from header.
s. Stop engine, and remove key.
t. Replace pin (J) in header legs, and secure with
ring (H).
O
N
P
J
H