MacDon CA25 OM - Manual (Page 78)

SECTION 7. OPERATION
169593
76
Revision B
d. Re-position left arm cylinder as follows:
NOTE
Reel components are not shown for
clarity.
1. Remove pin (A) securing cylinder (B) to
bracket/light assembly (C).
2. Remove bolts (D) securing bracket (C) to
reel arm and remove bracket/light
assembly.
3. If necessary, remove plastic tie securing
harness to bracket or reel arm.
4. Swivel light to working position as shown.
5. Re-position bracket/light assembly (C) on
reel arm as shown, and re-install the four
bolts (D) to secure bracket to reel arm.
Tighten bolts.
6. Push reel back, and re-install cylinder (B) to
bracket with pin (A). Secure pin with cotter
pin.
7. Secure light harness to bracket with plastic
tie wrap.
e. Check reel clearance to back sheet, upper
cross auger (if installed) and reel braces.
f. Adjust reel tine pitch if required. Refer to
Section 7.9.10 Reel Tine Pitch, or Section
8.12.1 Reel Clearance to Cutterbar for
adjustment procedures.
D
D
A
REARWARD POSITION
B
C
D
D
FORWARD POSITION
A
D
D
B
C