Warning – MacDon CA25 OM User Manual
Page 88
SECTION 7. OPERATION
169593
86
Revision B
7.14 UPPER CROSS AUGER
The cross auger helps deliver very bulky crops
across the header onto the windrow or into the
combine.
Removable beater bars assist in delivering
material through the header opening, but if
wrapping occurs, the beater bars can be
removed as follows:
WARNING
Stop engine, and remove key before
removing
plugged material from header. A
child or even a pet could engage the drive.
a. Lower header to ground, shut down combine,
and remove key.
b. Remove bolts (A) securing bars (B) and clamps
(C) to auger tubes, and remove bars and
clamps.
To re-install the beater bars:
a. Locate one beater bar (B) with one clamp set
(C) on auger tube, and loosely secure with
carriage bolt (A) and nut. Bolt head must face
direction of auger rotation.
b. Locate remaining clamp sets on tube, and
loosely attach to beater bar with carriage bolts
and nuts. Bolt heads must face direction of
auger rotation.
c. Position second beater bar in clamps, and
secure with carriage bolts and nuts.
d. Tighten
bolts.
DOUBLE REEL HEADERS
A
C
B
SINGLE REEL HEADERS
C
A
B