MacDon CA25 OM - Manual (Page 30)

SECTION 7. OPERATION
169593
28
Revision B
7.3 HEADER ATTACHMENT /
DETACHMENT
The header/adapter is configured to each
particular model of combine at the factory.
These combines are:
COMBINE SECTION
Case IH 7010, 8010, 7120,
8120, 5088, 6088, 7088
7.3.2
John Deere 60, 70 and
S Series
7.3.3
CAT Lexion 500, 700
(R Series)
7.3.4
New Holland CR, CX 7.3.5
AGCO Gleaner R, S Series
Challenger 660, 670, 680B
Massey 9690, 9790, 9895
7.3.6
This section includes instructions on setting up,
attaching, and detaching the header to the
combines listed above.
IMPORTANT
Ensure applicable functions (AHHC,
Draper Header Option, Hydraulic
Center-Link Option, Hydraulic Reel
Drive, etc.) are enabled on the
combine and in the combine
computer. Failure to do so may
result in improper header operation.
7.3.1 Adapter Set-up
The following sections outline recommended
adapter set-up guidelines, depending on your
combine and crop.
The recommendations cannot cover all
conditions.
If feeding problems develop with adapter
operation. For detailed information, refer to
Section 9 TROUBLESHOOTING.
7.3.1.1 Flighting Extensions
Flighting extension kits may have been supplied
with your header to improve feeding in certain
crops such as rice. Installation instructions are
included with the kits.
They are not recommended in cereal crops.
APPLICABLE COMBINES: All except New
Holland CR960, 9060, 970, 9070, and 9080.
If necessary, remove auger flighting extensions
as follows:
a. Remove access cover (A).
b. Remove eight bolts (B), washers, and nuts that
secure flighting extension (C) to auger and
remove extension.
c. Repeat for other flighting extension.
d. Re-install access cover (A).
A
C
B