MacDon CA25 OM - Manual (Page 123)

SECTION 8. MAINTENANCE AND SERVICING
169593
121
Revision B
D
8.6 ELECTRICAL
a. Use electrical tape and wire clips as required to
prevent wires from dragging or rubbing.
b. Keep lights clean, and replace defective bulbs.
c. To replace light bulbs:
1. Using a Phillips screwdriver, remove
screws from fixture, and remove plastic
lens.
2. Replace bulb, and re-install plastic lens and
screws.
NOTE
Bulb Part Numbers: Use Bulb Trade
#1156 for amber clearance lights and
#1157 for red tail light (Slow Speed
Transport option).
#1156 is 21W (12V).
#1157 is 21/5W (12V).
8.7 MAIN DRIVE
8.7.1 Driveline Removal
The main driveline normally remains attached
to the adapter, and is stored on the hook
provided when not in use.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. If adapter is attached to combine, remove
driveline from combine by pulling the quick
disconnect collar to release driveline yoke at
combine shaft.
b. Remove two nuts (A) attaching shield (B) to
gearbox.
c. Slide shield over poly driveline shield to expose
quick disconnect on gearbox. Do NOT
disconnect tether (C).
d. Pull quick disconnect collar to release driveline
yoke, and pull driveline off shaft.
e. Slide shield (B) off driveline.
f. Rotate disc (D) on
adapter driveline storage
hook, and remove the
driveline from hook.
C
A
C
B