MacDon CA25 OM - Manual (Page 59)

SECTION 7. OPERATION - ADAPTER
169593
57
Revision B
q. Raise reel fully, shut down engine, and remove
key from ignition.
r. Engage reel props.
WARNING
Keep hands clear of the area between
guards and sickle at all times.
s. Attach adapter feed deck:
1. Remove bolts (K) at either side of opening
to allow attachment of adapter deck.
2. Rotate latches (E) forward and down
engage transition pan tube (L).
3. Rotate latches (E) down with a 15/16 in.
wrench on hex (M) to raise feed deck so
that bolt (K) can be re-installed to lock the
latch position.
4. Repeat for other side of feed draper deck.
t. Install fillers (N) at each front corner of feed
deck with two 3/8 inch x 0.75 long hex head
bolts (O)
at each location.
u. Connect knife and draper drive hydraulics as
shown above, matching colored plastic cable
ties.
v. Attach electrical connector (P):
1. Remove cover on receptacle.
2. Align lugs on conne c tor with slots in
receptacle, push connector onto receptacle
and turn collar on connector to lock it in
place.
3. Attach cover to mating cover on combine
wiring harness.
(continued next page)
N
O
E
L
K
E
M
K
P