MacDon CA25 OM - Manual (Page 32)

SECTION 7. OPERATION
169593
30
Revision B
7.3.1.4 CR Feeder Deflectors
For New Holland CR 960, 9070, and 9080
combines, feeder kits have been installed on
the adapter at the factory to improve feeding
into the feeder house.
They may also have been installed as an option
on older machines. If necessary, they can be
removed.
CA25 adapters for the CR Models listed have
short feeder kits installed at the factory. Long
feeder kits are provided for narrow feeder
house combines, and are dealer-installed to
replace the short feeder kits.
COMBINE
MODEL
FEEDER
HOUSE SIZE
FEEDER KIT SIZE
CR970,
9070, 9080
Wide
Short: 7-7/8 in.
(200 mm)
CR960,
9060, 940,
9040
Narrow
Long: 12-13/16 in.
(325 mm)
If required, replace the feeder deflectors as
follows:
a. Determine position of existing deflector (A) by
measuring gap ‘X’ between deflector forward
edge and pan.
b. Remove two bolts (B), and nuts securing
deflector (A) to adapter frame and remove
deflector.
c. Position replacement deflector, and secure with
bolts (B) and nuts. Maintain dimension ’X’ from
existing deflector for replacement deflector.
d. Repeat for opposite deflector.
e. After attaching header to combine, extend
center-link fully, and check gap ’X’ between
deflector and pan.
f. Maintain 7/8 +/- 1/8 in. (22 +/- 3 mm).
LH SHOWN - RH OPPOSITE
A
B
X
A