MacDon CA25 OM - Manual (Page 24)

SECTION 6. SPECIFICATIONS
169593
22
Revision B
HEADER SIZE 20 FT 25 FT 30 FT 35 FT 40 FT 45 FT
UPPER CROSS AUGER
Outside Diameter 12 in. (305 mm)
Weight (lb [kg]) 135 (62) 205 (93) 235 (107) 265 (120) 295 (134)
STABILIZER WHEELS / SLOW SPEED TRANSPORT
Size
Not Applicable
ST205/75 R15
Pressure Load Range E - 85 psi (586 kPa)
COMBINE ADAPTER
Width 151 inches (3835 mm)
Length 70 inches (1778 mm)
Height 50 inches (1270 mm)
Weight 2,050 lb (930 kg)
Main Drive Combine Driven Piston Pump and Gear Pump Through Gearbox
Gearbox Capacity 5 Pints (2.5 liters)
Auger
Drive Chain
Type Auger - 14 inches (356 mm) with 4 inch (102 mm) Flighting
Speed 150 rpm (Combine Dependent)
Feed Draper
Drive Hydraulic Motor from Combine Driven Pump
Type Self-Tracking Rubber Coated Polyester Fabric With Rubber Slats
Width 78-3/4 inches (2000 mm)
Speed 350–400 ft / min (107–122 meters / min)
Reservoir Capacity 16 U.S. gal (60 liters)
Maximum Operating Pressure 3500 psi (24132 kPa) Piston Pump, 3700 psi (25510 kPa) Gear Pump
Filter 10 micron #151975
Header Draper Drive Pump 1.01 in. 3 (16.5 cc) Gear Pump
Sickle Drive Pump 1.8–2.7 in. 3 (29.5–44.2 cc) Piston Pump
Adapter Header Flotation 7–8 inches (178–203 mm) vertical, 4 degrees rotation
Header Angle Control
Mechanical or Hydraulic From Combine Hydraulic Oil Supply
(With Solenoid Valve To Toggle To Reel Fore-aft / Header Tilt)
Combine Requirement Class 5 or Higher
* See chart under Knife Speed for recommended range.
NOTES: 1. Specifications and design are subject to change without notice or obligation to revise previously sold units.
2. Weights do not include options.