MacDon CA25 OM - Manual (Page 45)

SECTION 7. OPERATION - NEW HOLLAND CR, CX
169593
43
Revision B
7.3.5 New Holland CR, CX
7.3.5.1 Attachment
a. Ensure handle (A) is positioned so that hooks
(B) can engage adapter.
b. Slowly drive combine up to adapter until feeder
house saddle (C) is directly under the adapter
top cross member (D).
c. Raise feeder house to lift adapter, ensuring
feeder saddle is properly engaged in adapter
frame.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
d. Lift lever (E) on adapter at left side of feeder
house, and push handle (A) on combine so that
hooks (B) engage pins (F) on both sides of the
feeder house.
e. Push down on lever (E) so that slot in lever
engages handle to lock handle in place.
f. If hook (B) does not fully engage pin on adapter
when (A) and (E) are engaged, loosen bolts
(G), and adjust lock as required. Re-tighten
bolts.
g. Open cover (J).
h. Push in lock button (K), and pull handle (L)
halfway up to open position.
(continued next page)
B
A
A
E
B
G
F
L
J
K
C
D