MacDon CA25 OM - Manual (Page 172)

SECTION 8. MAINTENANCE AND SERVICING
169593
170
Revision B
f. Slip chain (E) off drive sprocket (L).
g. Remove sprocket (L) from shaft.
IMPORTANT
Do NOT use pry bar and/or hammer
to remove sprocket. This will
damage the motor. If sprocket does
not come off by hand, use a puller.
h. Disconnect hydraulic lines (M) at motor (N).
Cap or plug open ports and lines.
i. Slide motor (N) and motor mount (O) up or
down so that attachment bolts (P) are exposed
in holes and slots in back plate.
j. Remove four nuts (Q) and bolts (P), and
remove motor (N).
k. Position new hydra u lic motor (N) on motor
mount (O), and install four countersunk bolts
(P) through holes and slots in chain case to
secure motor to motor mount.
l. Install nuts (Q), and torque to 75 ft·lbf
(102 N·m).
(continued next page)
L
E
O
M
N
P
Q
N
O