MacDon CA25 OM - Manual (Page 33)

SECTION 7. OPERATION - CASE IH
169593
31
Revision B
7.3.2 Case IH 7010, 8010, 7120, 8120, 5088,
6088, 7088
7.3.2.1 Attachment
a. Slowly drive combine up to adapter until feeder
house saddle (A) is directly under the adapter
top cross member (B).
b. Raise feeder house slightly to lift adapter,
ensuring feeder saddle is properly engaged in
adapter frame.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
c. Lift lever (C) on adapter at left side of feeder
house, and push handle (D) on combine to
engage locks (E) on both sides of the feeder
house.
d. Push down on lever (C) so that slot in lever
engages handle to lock handle in place.
e. If lock (E) does not fully engage pin on adapter
when (C) and (D) are engaged, loosen bolts
(F), and adjust lock as required. Re-tighten
bolts.
f. Connect combine hydraulic quick coupler to
receptacle (G) on adapter as follows:
1. Open cover (H).
2. Push in lock button (J), and pull handle (K)
to full open position.
3. Remove coupler (L) from combine, and
clean mating surfaces.
(continued next page)
L
M
K
H
J
N
G
A
B
D
C
E
F