MacDon CA25 OM - Manual (Page 55)

SECTION 7. OPERATION - ADAPTER
169593
53
Revision B
b. Engage the adapter float locks by lifting lever
(G) until it latches into the lock position.
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift
cylinder stops before going under header
for any reason. See your Combine
Operator’s Manual for instructions for use
and storage of header lift cylinder stops.
c. Disengage reel props, start engine, lower reel
and raise header fully. Stop engine, remove
key, and engage combine lift cylinder locks.
d. Remove ring (H) from pin (J), and remove pins
from header legs at delivery opening.
e. Place two 6 inch (150 mm) blocks (K) under
header legs at delivery opening.
NOTE
Stabilizer/Transport wheels can be
used to support header.
f. Disengage lift cylinder locks.
g. Start engine and lower header until it rests on
blocks (K) (or stabilizer wheels) and the ground.
NOTE
Length of hydraulic center-link may
need to be adjusted to relieve load on
link.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
h. Stop engine, and remove key from ignition.
i. Disconnect hydraulic center-link:
1. Remove lynch pin and clevis pin (L), then
lift center-link (M) clear of bracket.
2. Replace pin (L), and secure with lynch pin.
(continued next page)
G
LOCK
UNLOCK
L
M
J
H
K
GROUND