MacDon CA25 OM - Manual (Page 91)

SECTION 7. OPERATION
169593
89
Revision B
4. Remove clevis pin (F), and set aside for
later installation.
5. Push latch (G), and lift tow-bar (H) from
hook. Release latch.
c. Store tow-bar on header as follows:
1. Locate larger end of one section of tow-bar
in cradle (K) on header back-tube.
2. For clevis or pintle end of tow-bar, secure in
support (L) on endsheet with hitch pin (M).
Secure with lynch pin.
3. Install rubber strap (N) on cradle.
4. Similarly locate other section of tow-bar in
cradle at other end of header.
5. Secure tube end in support (O) with clevis
pin (P). Secure with hairpin.
6. Install rubber strap (N) on cradle.
d. Attach header to combine. Refer to Section 7.3
HEADER ATTACHMENT/DETACHMENT.
IMPORTANT
Carrying the tow-bar on the header
will affect the main header float.
Refer to Section 7.9.2 Header Float
for adjustment procedures.
H
F
G
PINTLE
M
L
N
K
P
O
M
L
CLEVIS