MacDon CA25 OM - Manual (Page 124)

SECTION 8. MAINTENANCE AND SERVICING
169593
122
Revision B
8.7.2 Driveline Installation
IMPORTANT
If combine output shaft splines
match adapter input shaft splines,
ensure driveline is installed with
longer guard at adapter gearbox
end.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Slide driveshaft in hook (E) so that disc (D)
drops to secure driveshaft.
b. Slide shield (B) over driveline.
c. Locate driveline quick disconnect onto adapter
gearbox shaft, pull back collar, and slide onto
shaft until yoke locks onto shaft. Release
collar.
d. Position shield (B) on gearbox, and secure with
nuts (A).
e. Re-connect other end to combine if necessary.
8.7.3 Guard Removal
The main driveline guard normally remains
attached to the driveline.
If removal is required for maintenance, proceed
as follows:
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
NOTE
The driveline does not need to be
removed from the adapter in order to
remove the driveline guard.
a. Rotate disc (D) on adapter driveline storage
hook (E), and remove driveline from hook.
b. Lift combine end of driveline (F) from hook, and
extend driveline until it separates. Hold adapter
end of driveline to prevent it from dropping and
hitting the ground.
c. Release grease zerk/lock (G) with a
screwdriver.
(continued next page)
F
G
A
B
D
E