MacDon CA25 OM - Manual (Page 29)

SECTION 7. OPERATION
169593
27
Revision B
b. If adjustments are required, proceed as follows:
1. Open endshield. See Section 7.2.3.1
Opening.
2. From inside endsheet, loosen nut (A) on
pin (B) with a 3/4 inch socket.
3. Close endshield, and adjust position to
achieve the gap ‘X’ between the front end
of shield and header frame. (on previous
page).
4. Open endshield, and tighten nut (A).
5. To achieve a snug fit between top of shield
and header frame, and to ensure that
endshield is fully engaged on pin (B),
loosen bolts on catch (C), and adjust catch
as required to re-position shield.
6. Tighten bolts on catch (C).
7. Close endshield.
7.2.4 Daily Start-Up Check
Do the following each day before start-up:
CAUTION
 Clear the area of other persons, pets etc.
Keep children away from machinery.
Walk around the machine to be sure no
one is under, on, or close to it.
 Wear close fitting clothing and
protective shoes with slip resistant
soles.
 Remove foreign objects from the
machine and surrounding area.
 As well, carry with you any protective
clothing and personal safety devices
that COULD be necessary through the
day. Don't take chances.
 You may need:
o a hard hat
o protective glasses or goggles
o heavy gloves
o respirator or filter mask
o wet weather gear
o Protect against noise. Wear a
suitable hearing protective device
such as ear muffs or ear plugs to
protect against objectionable or
uncomfortable loud noises.
a. Check the machine for leaks or any parts that
are missing, broken, or not working correctly.
NOTE:
Use proper procedure when searching
for pressurized fluid leaks. Refer to
Section 8.5 HYDRAULICS.
b. Clean all lights and reflective surfaces on the
machine.
c. Perform all Daily maintenance. Refer to Section
8.4.1 Maintenance Schedule/Record.
B
A
C