MacDon CA25 OM - Manual (Page 83)

SECTION 7. OPERATION
169593
81
Revision B
Headers Without Latch Option
a. Raise header, and engage lift cylinder lockouts.
Refer to combine operating manual.
b. Open header endshield. Refer to Section 7.2.3
Endshields.
c. Remove bolt (A).
d. Lower divider (B).
e. Lift divider off endsheet.
f. Close header endshield.
7.9.12.2 Installation
Headers with Latch Option
a. Open header endshield.
b. At divider storage location, lift divider to
disengage lugs (C) at lower end, and then lower
it slightly to disengage pin (D) from endsheet.
c. Position crop divider as shown by locating lugs
(C) in holes in endsheet.
d. Lift forward end of divider until pin (D) at top of
divider engages and closes latch (E).
e. Push safety lever (F) down to lock pin in latch.
f. Check that divider does not move laterally.
Adjust bolts (G) as required to tighten divider
and remove lateral play when pulling at divider
tip.
g. Close endshield.
(continued next page)
D
C
F
E
D
C
G
B
A