Apple PC Compatibility Card - Manual (Page 275)

PROTOCOL.INI (in the directory where the Banyan software is installed)
[VINES_NIF]
DRIVERNAME=NDISBAN$
BINDINGS=MACNDIS
[MACNDIS]
DRIVERNAME=MACNDIS$
PROTOCOLDIX=BAD
Installing NetManage Chameleon TCP/IP software
in Windows for Workgroups
This section describes the steps necessary to install the NetManage
Chameleon TCP/IP protocol for use with the either an ODI or NDIS driver in
Windows for Workgroups.
If you are using an ODI-compatible protocol, be sure to install the Novell
NetWare client software first. See the appropriate section on installing
NetWare client software earlier in this appendix.
1 Run the Chameleon/NFS Installer and follow the instructions in the NetManage manual
and on screen.
2 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
3 After running SETNET, make sure your files include the following entries:
AUTOEXEC.BAT
C:\NETMANAG\NMODI
WARNING You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.
275 Installing Network Client Software