Apple PC Compatibility Card - Manual (Page 245)

245 Installing Network Client Software
Installing NetWare client software version 1.02 for Windows 95
The NetWare client software that’s installed under Windows 95 can use either
the NDIS or ODI driver (unlike Windows for Workgroups and DOS, where
only the ODI driver can be used). The following steps describe how to install a
NetWare client under Windows 95 using the ODI driver.
1 Switch to the PC environment and start Windows 95.
2 In Windows 95, click Start and then select Shutdown from the menu that appears.
3 In the window that appears, select “Restart the computer in MS-DOS mode.”
4 Insert the NetWare Client Kit Disk 1 into the disk drive.
5 To switch to the disk, type the following:
A:
6 To start the installation process, type the following:
INSTALL
7 Follow steps 4–7 in the section “Installing NetWare Client Software Version 1.02 for
DOS/Windows for Workgroups,” earlier in this appendix.
8 When installation is complete, return to Windows 95 by typing the following:
EXIT
9 When Windows 95 restarts, you see an error message. Press Return.
The error message is
C:\windows\system\vmm32\vnetbios.VXD does not exist
10 Click Start, choose Settings from the menu that appears, and then select Control Panel.
11 Double-click the Network icon to open it.
12 Select Add in the Network control panel.
13 Select the Adapter Component in the Network Component list, then click Add.
14 Under Manufacturers, select (detected net drivers).