Apple PC Compatibility Card - Manual (Page 253)

IMPORTANT The Windows for Workgroups Network Browser requires more
than 540K of conventional memory. You should maximize conventional
memory by removing unnecessary device drivers and TSRs and by loading
the remaining device drivers and TSRs into high memory, if possible.
1 Install the NetWare client software.
For more information, see the appropriate section on installing NetWare
client software earlier in this appendix.
2 In the Network Setup control panel, select Drivers, select Add Adapter, and select
“IPXODI Support Driver (Ethernet).”
3 Select “IPX/SPX Compatible Transport With NetBIOS.”
4 Select your frame type.
5 Set the default protocol.
6 If you installed NetWare, you’re asked you if you want to replace the Novell NetWare
drivers. Select No.
7 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
8 Verify that your configuration files contain the following information.
After following the above instructions, your configuration files should contain
the information shown here, assuming a frame type of ETHERNET_802.2
and assuming that NetBEUI is not installed.
WARNING You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.
253 Installing Network Client Software