Apple PC Compatibility Card - Manual (Page 234)

Removing the card
1 Open the computer.
IMPORTANT For detailed instructions on opening your computer, including
safety precautions, see the chapter earlier in this manual on installing the PC
Compatibility Card in your model of computer.
2 Remove any cables from the PC Compatibility Card ports.
If you have not already done so, remove the loopback cable, and the PC game
controller cable (if one is attached), from the ports on the back of the PC
Compatibility Card.
3 If there is an internal audio/video assembly installed, detach it from the PC
Compatibility Card.
If you are removing a previous PC Compatibility Card from a Power
Macintosh 7200, you may see a ribbon cable, called the internal audio/video
assembly, not described in this book. This cable was installed on cards in
previous models of the 7200, and is described in the manual that came with
your computer or previous PC Compatibility Card. You’ll need to detach this
cable also (you won’t use it with your new PC Compatibility Card).
WARNING Your PC Compatibility Card may contain sockets for
additional video RAM. To avoid damage to your computer, Apple
recommends that you have your Apple-authorized dealer install
additional video RAM (for a fee). If you attempt to install additional
video RAM yourself, any damage you may cause to your equipment will
not be covered by the limited warranty on your computer. See an
Apple-authorized dealer or service provider for additional information
about this or any other warranty question.
234 Appendix B