Apple PC Compatibility Card - Manual (Page 259)

Installing Spry Air Series TCP/IP in Windows for Workgroups
This section describes how to install the Spry Air Series TCP/IP protocol for
use with an ODI driver in Windows for Workgroups.
IMPORTANT If you have not already installed TCP/IP client software such as
Microsoft TCP/IP-32 or Trumpet Winsock, install it before you install the Air
Series software.
If you are using a VGA driver and Air Series software version 2.0, you need to
make the following change:
1 Make sure the Air Series Setup disk is not locked.
2 Place the disk in drive A.
3 Type the following at the DOS prompt:
A:
MOVE SETUP.BMP SETUP.OLD
COPY C:\WINDOWS\RIVETS.BMP A:SETUP.BMP
To install Air Series from Windows, follow these steps:
1 Install the NetWare client software.
For more information, see the appropriate section on installing NetWare
client software earlier in this appendix.
2 Run the Air Series installation program.
During installation, select the option to install “Air Series applications (using
existing TCP/IP transport).” If you are not using this option, make sure that
MACODI.COM is in your \AIR\BIN directory and that your
AUTOEXEC.BAT file contains the following:
C:\AIR\BIN\MACODI
259 Installing Network Client Software