Apple PC Compatibility Card - Manual (Page 251)

Installing NetBEUI in Windows for Workgroups
This section describes the settings necessary to install the NetBEUI protocol
for use with an ODI driver in Windows for Workgroups. If you are using
NDIS 2.0, refer to this topic in “Installing Protocols for Use With Network
Driver Interface Specification (NDIS) 2.0,” later in this appendix.
1 Install the NetWare client software.
For more information, see the appropriate section on installing NetWare
client software earlier in this appendix.
2 In Windows, open the Network Setup control panel, click Drivers, and click Add Adapter.
3 Select “IPX ODI support driver (Ethernet)” and click OK.
Both NetBEUI and IPX/SPX protocols are installed. You can remove
IPX/SPX if it is not needed.
4 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
5 Make sure your configuration files contain the following:
NET.CFG
LINK DRIVER MACODI
FRAME ETHERNET_802.3
FRAME ETHERNET_II
FRAME ETHERNET_802.2
FRAME ETHERNET_SNAP
PROTOCOL NETBEUI F0 ETHERNET_802.2
NETWARE DOS REQUESTER
FIRST NETWORK DRIVER = F
WARNING You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.
251 Installing Network Client Software