Apple PC Compatibility Card - Manual (Page 230)

230 Appendix A
To remove a small plug attached to the card, grasp the sides of the plug and
pull firmly. It may help to gently rock the plug from side to side as you pull.
Do not attempt to use pliers to remove any plugs; you may damage the plugs,
the card, or your computer.
2 Remove any other cables from the PC Compatibility Card.
If you have not already done so, remove the loopback cable and the PC game
controller cable (if one is attached) from the ports on the back of the PC
Compatibility Card.
You may also need to remove the cables described below:
m If you are removing a previous PC Compabitility Card from a Power
Macintosh 7200, you may see a ribbon cable, called the internal
audio/video assembly, not described in this book. This cable was installed
on cards in previous models of the 7200, and is described in the manual
that came with your computer or previous PC Compatibility Card. You’ll
need to detach and remove this cable (you won’t use it with your new PC
Compatibility Card).
m If you are removing your PC Serial and Parallel Card also, detach the
peripheral flex cable from the PC Compatibility Card.
Gently rock
the plug. Don’t pull on
the cable.