Apple PC Compatibility Card - Manual (Page 257)

257 Installing Network Client Software
Installing Trumpet WinSock in Windows for Workgroups
This section describes how to set up the Trumpet WinSock protocol for use
with an ODI driver in Windows for Workgroups.
1 Install the NetWare client software.
For more information, see the appropriate section on installing NetWare
client software earlier in this appendix.
2 Gather all the files necessary for installing Trumpet WinSock, including
m TCPMAN.EXE
m TRUMPWSK.INI
m WINSOCK.DLL
m WINPKT.COM
m ODIPKT.COM
3 Make sure that all the Trumpet WinSock files are in the directory C:\TRUMPET.
4 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
WARNING You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.