Apple PC Compatibility Card User Manual
Page 255
[NWLINK]
BINDINGS=MACODI
FRAME=ETHERNET_802.2
Installing Microsoft’s TCP/IP-32 IP protocol stack
in Windows for Workgroups
Follow these steps to set up Microsoft’s TCP/IP-32 IP protocol stack for use
with an ODI driver in Windows for Workgroups.
1
Install the NetWare client software.
For more information, see the appropriate section on installing NetWare
client software earlier in this appendix.
2
Install the protocol stack following the instructions that came with it.
3
Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
4
After running SETNET, make sure the NET.CFG and PROTOCOL.INI files contain the
sections shown below.
The following entries assume that IPX/SPX support is loaded.
NET.CFG
LINK DRIVER MACODI
FRAME ETHERNET_802.2
FRAME ETHERNET_802.3
FRAME ETHERNET_II
FRAME ETHERNET_SNAP
PROTOCOL IPX E0 ETHERNET_802.2
PROTOCOL IP 800 ETHERNET_II
PROTOCOL ARP 806 ETHERNET_II
PROTOCOL RARP 8035 ETHERNET_II
continued
.
WARNING
You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.
255
Installing Network Client Software