Apple PC Compatibility Card - Manual (Page 248)

Installing NetWare Client 32 for DOS and Windows for Workgroups
To install NetWare client software version 2.01, follow these steps.
IMPORTANT For SETNET to work, the Client 32 software must be installed
under the NWCLIENT directory, not under the NOVELL\Clients32 directory.
1 In the PC environment, start from a DOS prompt.
If you are in Windows, close all windows and exit to a DOS prompt.
2 Insert the NetWare disk into the disk drive.
3 To run the NetWare Client Install program, type
A: \install
Follow the instructions that appear on the screen.
4 When prompted, press F10 to continue.
5 When prompted to select a LAN driver type, select the 16-bit LAN drivers, and press
Return.
A list of available 16-bit drivers will be displayed. Scroll down to the end of
the list and select “User Specified 16 Bit Driver.”
6 Insert the PC Compatibility Card–PC Software floppy disk.
The MacODI and MacNDIS drivers are located in the root directory on the
PC Compatibility Card–PC Software floppy disk.
7 Select “PC Compatibility Ethernet Adapter,” and press F10 .
8 Press Return, select the frame, then press Return.
9 Press F10 to continue.
10 Confirm the Installation Configuration Summary, then press F10.
11 Follow the instructions on the screen to complete the installation process.
Note: Installing the NetWare client software for the PC Compatibility Card is
similar to installing it on a PC. The only major difference is that the PC
Compatibility Card provides its own ODI drivers.
248 Appendix C