Apple PC Compatibility Card - Manual (Page 274)

AUTOEXEC.BAT (the lines must be at the end of the file)
SHARE
C:\NET\NET START
NETWORK.INI
[NETWORK]
COMPUTERNAME=<
name you specified >
LANROOT=C:\NET
AUTOSTART=FULL
GUICONFIG=0,0,1
USERNAME=<
name you specified >
DOMAIN=< name you specified >
LSLOGON=YES
RECONNECT=YES
PASSWORDCACHING=YES
[PASSWORD LISTS]
username =C:\NET\ username .PWL
Note: You can use the NETGUI command for Graphical DOS Network
management work. You can also use Windows if you have installed the
necessary Windows files.
If you have problems with OS/2 networking, please contact IBM.
Installing Banyan Vines in DOS
This section describes the settings you must make when using Banyan Vines
with an NDIS driver in DOS. Refer to the documentation that came with
Windows for Workgroups for other installation instructions.
1 Install the Banyan Vines client software.
2 Make sure your configuration files contain the following:
CONFIG.SYS
REM *** BANYAN ***
DEVICE=C:\BANYAN\PROTMAN.DOS /I:C:\BANYAN
DEVICE=C:\BANYAN\MACNDIS.DOS
274 Appendix C