Apple PC Compatibility Card - Manual (Page 243)

243 Installing Network Client Software
Installing protocols for use with Open Data-Link Interface (ODI)
Before you install a protocol for use with ODI, follow the instructions in this
section to install the appropriate NetWare client software. Then refer to the
instructions later in this section that describe installing and setting up the
network protocol you want to use.
Note: If you are installing Windows for Workgroups, the Novell NetWare
client, and TCP/IP support, it is easiest if you install the NetWare client first,
Windows for Workgroups second, and TCP/IP support third.
You need to know the Ethernet frame type in use on your network segment.
Your network administrator can give you this information.
Installing NetWare client software version 1.02 for
DOS/Windows for Workgroups
Note: These examples use NetWare client version 1.02 for DOS. If you intend
to use other NetWare client versions, then certain changes need to be made
for proper installation. LSL version 2.21 or later must be used with the latest
MACODI driver supplied with the PC Compatibility Card software.
1 In the PC environment, start from a DOS prompt.
If you are in Windows, close all windows and exit to a DOS prompt.
2 Insert the NetWare disk into the disk drive.
3 Run the NetWare Client Install program.
A: \INSTALL
4 Follow the instructions on screen for steps 1–3. Then select step 4 and press Return.
A list of network interface controller (NIC) drivers appears.
5 Eject the NetWare floppy disk by pressing
x
-E.
6 Insert the PC Compatibility Card–PC Software floppy disk and press Return.
The PC Compatibility Card–PC Software floppy disk has the
MACODI.COM driver.
7 From the list of choices, select “PC Compatibility Ethernet Adapter” and press Return.