Apple PC Compatibility Card - Manual (Page 260)

3 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
m If you are on a NetWare local area network and you’re using the Novell
VLM redirector, these lines should appear in this order:
REM CALL C:\NWCLIENT\STARTNET.BAT
C:\AIR\BIN\TCPIP
C:\NWCLIENT\VLM
m If you are using NETx, these lines should appear in this order:
C:\NWCLIENT\VLM
C:\AIR\BIN\TCPIP
Installing AppleShare for Windows in Windows for Workgroups
This section describes how to install and set up the AppleShare for Windows
protocol for use with an ODI driver in Windows for Workgroups.
1 Install the NetWare client software.
For more information, see the appropriate section on installing NetWare
client software earlier in this appendix.
2 Install AppleShare for Windows according to the instructions that came with it.
3 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
WARNING You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.
WARNING You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.
260 Appendix C