Allied Telesis AT-WL2411 - Manual (Page 95)

AT-WL2411 Installation and User’s Guide
95
❑ In the IP Tunnels screen, enable the Port Control parameter in all
access points that are root candidates and designated bridge
candidates.
❑ In the IP Tunnels screen, configure the Mode parameter in root
candidates to Originate if Root. Configure the Ethernet Address
table to include access points on each remote subnet. All root
candidates should be configured identically.
❑ In the IP Tunnels screen, configure the Mode parameter in
designated bridge candidates to Listen.
❑ In the Tunnel Filters screen, configure the filters in root candidates
and in other access points that can be attached through an IP
tunnel. IP tunnel filters are consistent with Ethernet filters.
❑ For networks using IP networking on end devices, it is
recommended that you enable the ARP server capability in the
access points.
❑ Determine if you need to enable bridging on remote subnets. For
example, bridging must be enabled if an NNL gateway is attached
to the remote subnet. For help, see Configuring the Spanning
Tree Parameters on page 74. The designated bridge candidates
must have permanent IP addresses and must be able to receive IP
hello messages from the root access point. An access point will
receive IP hello messages if the messages are sent to the unicast
IP address of the access point, or to an IP-directed broadcast or IP
multicast address. Note you may need to enable IGMP for IP
multicast.
To configure the IP Tunnels screen: