beautypg.com

About network address translation (nat) – Allied Telesis AT-WL2411 User Manual

Page 56

background image

AT-WL2411 Installation and User’s Guide

56

DNS Address 1
The IP address of a Domain Name Server that will be distributed to
DHCP clients. You can enter up to two DNS addresses to be
delivered to DHCP clients.

DNS Address 2
The IP address of a Domain Name Server that will be distributed to
DHCP clients. You can enter up to two DNS addresses to be
delivered to DHCP clients.

Lease Time
Specifies the duration of the leases that are granted by the DHCP
server. Enter the lease time in the format days:hours:minutes. If
you set the lease time to 0, infinite leases are granted

7. Click Submit Changes to save your changes and then click “here.” To

activate your changes, click the Save/Discard Changes link in the
menu bar and then click Save Changes and Reboot. For help, see
Saving Your Configuration Changes on page 46.

Supported DHCP Server Options.

The DHCP server issues IP address leases to configure this field:

IP broadcast address
The IP broadcast address, along with the subnet mask and IP
router, will contain the same values as those configured for the
access point.

Unsupported DHCP Server Options.

The DHCP server does not support any DHCP options other than those
listed. The DHCP server disregards any DHCP options that are not
explicitly required by the DHCP specification. The DHCP server ignores
all packets with a non-zero giaddr (gateway IP address). The DHCP server
only responds to requests from its own subnet.

About Network

Address

Translation

(NAT)

NAT allows IP addresses to be used by more than one device. The access
point can act as a NAT server, which instantaneously rewrites IP
addresses and port numbers in IP headers so that packets all appear to
be coming from (or going to) the single IP address of the access point
instead of the actual source or destination.

When a device uses the access point as an IP router, the access point
replaces the IP header, which includes the device’s MAC address, IP
source address, and TCP/UDP port, with its own. You can configure the
DHCP server to indicate that the access point is the IP router when the