Allied Telesis AT-WL2411 - Manual (Page 153)

AT-WL2411 Installation and User’s Guide
153
You cannot establish an IP tunnel to a
access point on a remote subnet. 1. Click TCP/IP Settings and verify that the IP Router
(Gateway) address is correct.
2. Click Spanning Tree Settings and verify that the
access points on both ends of the tunnel have the
same LAN ID.
3. Click IP Addresses from the IP Tunnels menu to
verify that the IP address of the remote access
point appears in the IP Addresses list.
The throughput seems slow.
❏ Verify that your antennas are well placed and
that they are not blocked by metal or other
obstacles.
❏ You may want to add a second access point and
implement roaming if you move the antenna
closer to the device and throughput increases.
You may be able to set filters to eliminate Ethernet
traffic on the wireless side of the network.
Problem/Question Possible Solution/Answer