Allied Telesis AT-WL2411 User Manual
Page 84
AT-WL2411 Installation and User’s Guide
84
Multicast Outbound to Secondary LANs
If multicast flood mode is not disabled, this parameter specifies if
outbound multicast frames with unknown destination addresses
are flooded toward secondary LANs.
Enabled
The root access point controls flooding for all access points
serving as designated bridges for the secondary LANs.
Set locally
Designated bridges for the secondary LANs control
flooding on their LANs.
Unicast Flood Mode
Determines the flooding structure for inbound unicast frames
with unknown destination addresses.
Universal
Allows any wireless end device to communicate with any
other wireless end device.
Hierarchical
Allows wireless end devices to communicate with nodes
on the primary LAN but not with other wireless end
devices.
Disabled
Prevents flooding.
Unicast Outbound to Terminals
If the unicast flood mode is not disabled, this parameter specifies
if outbound unicast frames with unknown destination addresses
are flooded toward wireless end devices. This parameter only
applies to 802.11b radios.
Unicast Outbound to Secondary LANs
If the unicast flood mode is not disabled, this parameter specifies
if outbound unicast frames with unknown destination addresses
are flooded toward secondary LAN segments.
Enabled
The root access point controls flooding for all access points
serving as designated bridges for the secondary LANs.
Set locally
Designated bridges for the secondary LANs control
flooding on their LANs.
4. Click Submit Changes to save your changes. To activate your changes,
click the Save/Discard Changes link in the menu bar and then click
Save Changes and Reboot. For help, see Saving Your Configuration
Changes on page 46.