Allied Telesis AT-WL2411 - Manual (Page 47)

AT-WL2411 Installation and User’s Guide
47
Using a Telnet Session
To establish a Telnet configuration session, you can:
1. Go to an MS-DOS prompt and type Telnet IPaddress, where
IPaddress has the form x.x.x.x and x is a number from 0 to 255. Use the
IP address assigned to the access point you want to configure.
OR
Open a Telnet program and type open. Press Enter. At the
prompt, type the IP address of the access point and press
Enter.
2. Follow the configuration instructions in Using a Serial Connection
on page 39, since the Telnet interface is similar to the
communications program interface.