Allied Telesis AT-WL2411 - Manual (Page 140)

AT-WL2411 Installation and User’s Guide
140
Restoring the Default Settings
You may need to restore the access point to the factory default configu-
ration. This can be done using the Web browser interface. For a list of the
default settings, see “Default Settings” in Appendix A. To restore the
default configuration:
1. In the menu bar, click Save/Discard Changes. The Changes screen
appears, as shown in Figure 64.
Figure 65 Changes
2. Click Restore Factory Defaults. Under Pending Changes, you will see a
list of what parameters need to be changed.
3. Click Save Changes and Reboot. When the access point is done
rebooting, it will use the factory default settings as its active
configuration. You may need to reset the IP address and other
network parameters.