Allied Telesis AT-WL2411 - Manual (Page 51)

AT-WL2411 Installation and User’s Guide
51
1. From the menu, click TCP/IP Settings. The TCP/IP Settings screen
appears, as shown in Figure 16.
Figure 16 TCP/IP Settings
2. Configure the TCP/IP settings using the following parameters:
IP Address
Enter the IP address of the access point. The IP address has the
form x.x.x.x, where x is a number from 0 to 225.
IP Subnet Mask
Enter the subnet mask that matches the other devices in your
network. The subnet mask has the form x.x.x.x, where x is a
number from 0 to 225.
IP Router
Enter the IP address of the router that will forward packets if the
access point will communicate with devices on another subnet.
The IP address has the form x.x.x.x, where x is a number from 0 to
225.
IP Frame Type
This parameter controls the encapsulation of IP frames sent by
this access point. You select either DIX (Ethernet 2.0) or SNAP
encapsulation.