Allied Telesis AT-WL2411 - Manual (Page 119)

AT-WL2411 Installation and User’s Guide
119
You need to set the root priority of the master radio to a number that is
greater than the root priority of the station radio. The devices will not
form a point-to-point bridge if the master radio has a lower root priority
than the station radio. On the master radio, you should also set the
Secondary LAN Bridge Priority parameter to 0 and the Secondary LAN
Flooding parameter to disabled. On the station radio, you should set
bridge priority parameter to a number other than 0 and the flooding
parameter to enabled.
You may also need to adjust the flooding parameters. Follow these
recommendations when configuring the flooding parameters for a
point-to-point bridge:
❑ If there are no wireless end devices on the secondary LAN, the
access point on the secondary LAN can use the default flooding
settings.
❑ If there are wireless end devices on the secondary LAN, the access
point on the secondary LAN should have its Secondary LAN
Flooding parameter enabled. Also, the Secondary LAN Bridge
Priority parameter must be non-zero.
❑ If there are wireless end devices on the secondary LAN and the
end devices communicate with end devices on another
secondary LAN, the root access point should have its Multicast
Flood Mode parameter set to Universal.
To configure the master radio (in the point-to-point bridge on the
primary LAN):
1. From the main menu, click the link corresponding to the radio that
you are configuring.