Allied Telesis AT-WL2411 - Manual (Page 48)

AT-WL2411 Installation and User’s Guide
48
Using SNMP
The access point supports SNMP management. Contact your Allied
Telesyn representative for information about obtaining a copy of the
MIB. The passwords for accessing the SNMP community table are shown
below.
Type of Access MIB Password
read only public
read/write CR52401
Configuring the
SNMP
Community
Simple Network Management Protocol (SNMP) community strings are
passwords used by SNMP. When you use an SNMP client, you must enter
the correct community string to gain access to the access point SNMP
interface.
To configure the SNMP community, do the following:
1. Establish a Web browser session if you have not already done so. For
more information, see Using a Web Browser on page 44.
2. Click Network Management. The Community Strings screen appears,
as shown in Figure 15.
Figure 15 Community Strings Screen