Allied Telesis AT-WL2411 - Manual (Page 67)

AT-WL2411 Installation and User’s Guide
67
Note
If you set the Scope field to Unlisted for any of the frame types, you
must also configure predefined subtype filters or customizable
subtype filters. For help, see Using Predefined Subtype Filters on
page 68 or Customizing Subtype Filters on page 68.
The various frame types are explained below:
DIX IP TCP Ports
DIX IP UDP Ports
SNAP IP TCP Ports
SNAP IP UDP Ports
Primary Internet Protocol Suite (IP) transport protocols.
DIX IP Other Protocols
SNAP IP Other Protocols
IP protocols other than TCP or User Datagram Protocol (UDP).
DIX IPX Sockets
Novell NetWare protocol over Ethernet II frames.
SNAP IPX Sockets
Novell NetWare protocol over 802.2 SNAP frames.
802.3 IPX Sockets
Novell NetWare protocol over 802.3 RAW frames.
DIX Other Ethernet Types
SNAP Other Ethernet Types
DIX or SNAP registered protocols other than IP or IPX.
802.2 IPX Sockets
Novell running over 802.2 Logical Link Control (LLC).
802.2 Other SAPs
802.2 SAPs other than IPX or SNAP.
Note
You cannot filter HTTP, Telnet, SNMP, and ICMP frames because they
are used for configuration and management of the access point.
Additionally, you cannot filter broadcast ARP request packets if the
target IP address belongs to the local access point or to an access
point in the subtree rooted at the local access point.
4. Click Submit Changes to save your changes. To activate your changes,
click the Save/Discard Changes link in the menu bar and then click
Save Changes and Reboot. For help, see Saving Your Configuration
Changes on page 46.