Allied Telesis AT-WL2411 - Manual (Page 110)

AT-WL2411 Installation and User’s Guide
110
2. Click Advanced Configuration. The Advanced Configuration screen
appears, as shown in Figure 45.
Figure 45 Advanced Configuration
3. Configure the advanced parameters. The advanced parameters are
described below:
Data Rate
Choose the rate at which the access point transmits data. In
general, higher speeds mean shorter range and lower speeds
mean longer range. You can set this rate to 11, 5.5, 2, or 1 Mbps.
Data Rate Fallback
Determines if you want the radio to drop to a slower data rate
when it has trouble communicating with another radio. This
parameter also limits your range to the Data Rate selected above.
Basic Rate
Choose the rate at which the access point transmits multicast
frames. In general, higher speeds mean shorter range and lower
speeds mean longer range. Do not set this rate higher than the
maximum rate at which your end devices can receive multicast
frames. You can set this rate to 11, 5.5, 2, or 1 Mbps. This
parameter should usually be left at the default 2 Mbps.