Allied Telesis AT-WL2411 - Manual (Page 55)

AT-WL2411 Installation and User’s Guide
55
3. Click the down arrow on the right side of the DHCP Mode field and
choose “This AP is a DHCP Server.”
4. Click Submit Changes to save your changes.
5. Click DHCP Server Setup. The DHCP Server Setup screen appears, as
shown in Figure 19.
Figure 19 DHCP Server Setup
6. Configure the DHCP server using the following parameters:
Low Address
The low IP address in the range of IP addresses available to the
DHCP server for distribution to DHCP clients. If these addresses
are not on the same subnet as the access point, the access point
will perform Network Address Translation (NAT) for the devices to
which it grants IP addresses.
High Address
The high IP address in the range of IP addresses available to the
DHCP server for distribution to DHCP clients. If these addresses
are not on the same subnet as the access point, the access point
will perform Network Address Translation (NAT) for the devices to
which it grants IP addresses.