Allied Telesis AT-WL2411 - Manual (Page 65)

AT-WL2411 Installation and User’s Guide
65
2. Click Address Table. The Address Table screen appears, as shown in
Figure 24.
Figure 24 Address Table
3. Enter up to 20 MAC addresses. MAC addresses consist of six hex pairs
that are separated by spaces, colons, or hyphens.
4. Click Submit Changes to save your changes. To activate your changes,
click the Save/Discard Changes link in the menu bar and then click
Save Changes and Reboot. For help, see Saving Your Configuration
Changes on page 46.
Using Ethernet
Frame Type
Filters
You can define filters for common networking protocols such as IP,
Novell IPX, and 802.2 LLC. You can also set filters that will pass only those
Ethernet frame types found on your network.
You can set the default action for general and specific frame types. For
example, you can set the DIX-Other EtherTypes frame parameter to
drop, and then use the subtype menus to pass only those specific DIX
types that are used in your radio network.
You can also set the scope for general and specific frame types. For
example, you can set the action to Drop and the scope to All for DIX-IP-
TCP Ports, and then all IP packets with the TCP type will be dropped even
if specific TCP parts are set to pass in the subtype menus.