Allied Telesis AT-WL2411 - Manual (Page 161)

161
FFR Purpose
Runs a program that is specified by f, from a location specified by s.
Syntax
FFR f ( s )
where:
f is the program name.
s is the optional segment location of the program.
Example: To run program access pointBOOT.PRG from segment 1, enter:
FFR access pointBOOT.PRG 1
PN Purpose
Returns the access point to normal mode from quiet mode.
Syntax
PN
To return the access point to normal mode
1. Reboot the access point.
2. The LEDs flash on and off during the reboot. When the LEDs flash off
and only the Power LED remains lit, type !!! (three exclamation points).
The access point prompt (access point>) appears.
3. Type SRVC and press Enter.
4. Type the service password (the default is EV98203S) and press Enter.
The service prompt (service>) appears.
5. Type PN and press Enter.
6. Type B to reboot the access point in normal mode.
PQ Purpose
Puts the access point in quiet mode. When the access point is in quiet
mode, you cannot access the access point monitor. You may want to use
quiet mode for security reasons.
Syntax
PQ